Rs422 converter circuit

New posts. Search forums. Log in. Install the app. Contact us. Close Menu. Welcome to EDAboard. To participate you need to register. Registration is free. Click here to register now. Register Log in. JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.

You are using an out of date browser. RS is also specified for multi-drop party-line applications where only one driver is connected to, and transmits on, a "bus" of up to 10 receivers. While a multi-drop "type" application has many desirable advantages, RS devices cannot be used to construct a truly multi-point network.

A true multi-point network consists of multiple drivers and receivers connected on a single bus, where any node can transmit or receive data. These networks are often used in a half-duplex mode, where a single master in a system sends a command to one of several "slave" devices on a network.

Typically one device node is addressed by the host computer and a response is received from that device. Systems of this type 4-wire, half-duplex are often constructed to avoid "data collision" bus contention problems on a multi-drop network more about solving this problem on a two-wire network in a moment.

Both RS and RS use a twisted-pair wire i. The main difference between RS and RS is that while RS is strictly for point-to-point communications and the driver is always enabled , RS can be used for multidrop systems and the driver has a tri-state capability. The electrical characteristics of the balanced voltage digital interface are designed to allow use of both balanced and unbalanced see EIA Standard RSA circuits within the same interconnection cable sheath.

For example, the balanced circuits may be used for data and timing while the unbalanced circuits may be used for low speed control functions. Since the basic differential receivers of RSA and RSA are electrically identical, it is possible to interconnect an equipment using RSA receivers and generators on one side of the interface with an equipment using RSA generators and receivers on the other side of the interface, if the leads of the receivers and generators are properly configured to accommodate such an arrangement and the cable is not terminated.

The balanced interface circuit is not intended for interoperation with other interface electrical characteristics such as RSC.

Under certain conditions. Making sense of cable specifications Selecting data cable for an RS or RS system isn't difficult, but often gets lost in the shuffle of larger system issues. Care should be taken. Circuit grounding is not shown in either of the RS or RS circuits. However, the circuits should be grounded. The drivers and receivers should be connected directly to circuit ground.

The circuit ground should be connected to chassis ground via a ohm resistor. If the far-end circuit resides in another chassis, then the two circuit grounds should be connected together via a ohm resistor at each end. Steering Diodes [1N] may also be added to the input lines to protect the RS receivers. It is intended for United States, non-military government use.

It is intended for the United States, non-military government use. The resistors are normally required once the system has reached it's quiescent state, when no drivers are driving the bus.